Additional type two component Silicone Rubber/Gel for LED ,IC Encapsulating / Packageing use
Code No. RAY-8636 in 1: 1 ratio
Introductions :
Due to the energy saver, best brightness and higher powder LEDs was applied on very field,as general illumination backlight for LCD, and Automotive light. In encapsulation epoxy resin can not stand heat cycle on applications?A new product Silicone rubber ,which had heat and weather resistant ,could be apply on electric circles and LEDs used.
Uncured properties :
RAY8636-A
viscosity: 1200 cps
special gravity 1.01
appearance transparency
RAY8636-B
viscosity : 1500 cps
special gravity 1.01
appearance transparency
Properties after cured :
Volume resistivity: > 1.0 x 1015 ohm-cm
Dielectric strength: > 20 Kv/mm
Color colorless
refraction 1.41
Transmittance%: 95%
Hardness Shore : 70 (ShoreA)
Lost on heat < 0.1%
Tension strength 12. kg/cm2
Shrinkage 0.2%
Operation process :
weight : Take RAY8636- A and RAY8636- B by 1:1 (weight ratio).
Defoaming place the mixture in vacuum vessel.and kept vacuum lower than 500 mg Hg.
Filler : Be careful pouring silicone to the container, avoid occur bubble
Harden : Preheating 100 oC X 50 min. then Curing 150oC X 240 min.
Products are MADE IN TAIWAN
